This guide is designed to offer a comprehensive set of instructions for the installation and operation of palm oil primary processing equipment for small and medium-sized farms and primary processing enterprises. It focuses on the installation process of the small palm oil screw press from Penguin Group, including space planning, power supply configuration, initial startup debugging, and daily maintenance techniques.
Before installing the small palm oil screw press, it is crucial to ensure that the construction environment meets the requirements of the machine's size and voltage. The small screw press usually has a length of about 2 - 3 meters, a width of 1 - 1.5 meters, and a height of 1.5 - 2 meters. Therefore, the installation space should be carefully measured to avoid any spatial constraints during the installation process.
In terms of power supply, the small screw press generally requires a 380V three - phase power supply. The power cable should be thick enough to handle the power load of the machine, usually a cable with a cross - sectional area of 6 - 10 square millimeters is recommended. This ensures stable power supply during the operation of the equipment.
The initial startup debugging is a key step to ensure the stable operation of the equipment. First, perform a pressure calibration. The pressure of the screw press should be adjusted according to the characteristics of the palm fruits. Generally, the pressure should be calibrated to 10 - 15 MPa to ensure efficient oil extraction.
During the startup, carefully observe the oil - output state. The oil should flow out smoothly without any blockage. If there are any abnormal situations, such as uneven oil output or oil splashing, stop the machine immediately and check for problems.
Regular cleaning and maintenance of the equipment can significantly extend its service life and reduce the risk of downtime. After each use, clean the oil residue inside the machine. Use a soft brush to remove the oil cake and oil residue on the screw and the inner wall of the press chamber.
Lubricate the moving parts of the machine regularly. For example, add lubricating oil to the bearings every 20 - 30 working hours to ensure smooth operation. This can prevent mechanical wear and reduce the occurrence of faults.
When the equipment encounters problems such as abnormal noise or a decrease in oil output rate, there are corresponding solutions. If there is abnormal noise, it may be due to loose parts or lack of lubrication. Check the bolts and nuts of the machine to ensure they are tightened, and add lubricating oil to the relevant parts.
If the oil output rate decreases, it may be caused by blockage of the oil outlet or improper pressure adjustment. Clean the oil outlet and re - calibrate the pressure according to the correct steps.
The small palm oil screw press from Penguin Group features a high - strength iron structure. This structure can withstand the harsh environment of frequent movement in farms. It has strong durability and can adapt to different geographical and climatic conditions, making it suitable for use in various farms.
This guide combines various content forms such as text, pictures, and interactive Q&A to achieve the best combination of knowledge transfer and user operation guidance. It not only meets the needs of operation guidance but also provides technical explanations and user care, building a systematic knowledge base.
Get the complete installation guide PDF for free and book a remote technical support session now! Click here to take the first step towards efficient palm oil processing!
